When you add a new LNB, you may need to change your satellite receiver, as not all units support multiple satellite signals. However, you will not need to upgrade your other LNBs. If you add a LNB that uses a different standard, you will need to upgrade your switch. The receiver can then send requests, which are routed through the DiSEqC switch, for specific satellite signals.įortunately, DiSEqC switches are backwards compatible. This notifies the receiver of the LNBs available and what they are receiving. The switch sends the signals from the LNBs to your satellite receiver. The process of signal reception is the same as that performed by a standard dish to receiver connection, with the DiSEqC switch directing traffic between the various components. A DiSEqC switch sends bidirectional signals and electricity through the coaxial cables to select and control the appropriate LNB. A regular coaxial splitter/combiner is used primarily for sending a cable signal to multiple televisions or consolidating the signals of multiple antennas to one line. However, a standard coaxial splitter/combiner cannot be substituted for a DiSEqC switch. DiSEqC, which stands for digital satellite equipment control, switches are used to control multiple LNBs and the signals they send.Ī DiSEqC switch resembles a coaxial splitter/combiner, with multiple inputs for LNBs and one output to a satellite receiver. If you use multiple satellite services, such as both foreign and local broadcasting, but want to use a single receiver, you will need a DiSEqC switch. Each satellite service needs a dedicated LNB. The LNB receives the satellite signal, much like an antenna receives an over-the-air broadcast, and sends them to your satellite receiver to be displayed on your television. DiSEqC was developed by European satellite provider Eutelsat, which now acts as the standards agency for the protocol.Īll satellite dishes have flashlight-shaped attachments known as LNBs. DiSEqC (Digital Satellite Equipment Control), pronounced 'Die-Sec', citation needed is a special communication protocol for use between a satellite receiver and a device such as a multi-dish switch or a small dish antenna rotor.
0 kommentar(er)
